Hello, I am new here but I did a search and could not find an answer to my question.
I am currently converting my single tap tower on my Sanyo BC-1206 with a three tap tower and I need to drill new holes. Does anyone know where I can find the coil locations of this model so that I don't do any harm in the process? There is thick slab of MDF of the top but the screws that came with the tower are much longer than this. Any advice would be most helpful so I don't go from "WOOT! Getting three taps" to "crap, now I don't have a working kegerator at all."
Thanks in advance.
I am currently converting my single tap tower on my Sanyo BC-1206 with a three tap tower and I need to drill new holes. Does anyone know where I can find the coil locations of this model so that I don't do any harm in the process? There is thick slab of MDF of the top but the screws that came with the tower are much longer than this. Any advice would be most helpful so I don't go from "WOOT! Getting three taps" to "crap, now I don't have a working kegerator at all."
Thanks in advance.