I'm considering going the Brewtroller route for my system but have some questions.
1. Any Mac based software for control or firmware updates?
2. Any hopes or news of web interface?
3. Anyone know what the cutout dimension is for the 20x4 LCD? Any pre-made snap-in style of bezels for the LCD...I couldn't find crap.
4. Any thoughts on putting the LCD and encoder in a smaller sloped front enclosure on my brewing table top and then running cables for those to the Brewtroller board in my control box mounted under the table? Short cable run and could use shielded cable if needed.
The Brewtroller has tons of setup ease with LED and switch pin headers already incorporated onboard but before I take the plunge and redo my panel was hoping for some help.
Thanks in advance.
1. Any Mac based software for control or firmware updates?
2. Any hopes or news of web interface?
3. Anyone know what the cutout dimension is for the 20x4 LCD? Any pre-made snap-in style of bezels for the LCD...I couldn't find crap.
4. Any thoughts on putting the LCD and encoder in a smaller sloped front enclosure on my brewing table top and then running cables for those to the Brewtroller board in my control box mounted under the table? Short cable run and could use shielded cable if needed.
The Brewtroller has tons of setup ease with LED and switch pin headers already incorporated onboard but before I take the plunge and redo my panel was hoping for some help.
Thanks in advance.