jcb317
Well-Known Member
I've been reading up around here about cutting the top of the keggle open and i have access to two methods i've seen so far, grinder and sawzall/recip saw. From what i've seen, all the guys cutting with the recip were using bi-metal metal cutting blades. Has anyone tried carbide grit, carbide tip, or titanium tipped bi-metal blades? These are just some examples of each bellow from Lenox, i have seen higher TPI carbide tipped blades than the ones in the link bellow that would be better suited for metal cutting. Just looking for some feedback to see if anyone has tried these with any success.
Thanks!
http://www.lenoxsaw.com/recip_gold.htm
http://www.lenoxsaw.com/gritrecp.htm
http://www.lenoxsaw.com/carbiderecip.htm
Thanks!
http://www.lenoxsaw.com/recip_gold.htm
http://www.lenoxsaw.com/gritrecp.htm
http://www.lenoxsaw.com/carbiderecip.htm