dirtybear7
Well-Known Member
MobileMe Gallery
I've posted photos to the above page of my new Blichmann Top Tier burner. I noticed it is missing one of the four screws that attach the burner to the frame. Not a big deal as long as they send me a replacement screw. Here is where my concern is, when I tried to use one of the other three screw in that hole it couldn't reach the burner because of the large gap between the round frame and the burner. Does anyone know if the burner should be flush to the frame or is there some wiggle room? I also found the the other screws to the burner were pretty loose. Has anyone else had to tighten up the burner when they got theirs new? I hate to have to send it back, but it cost too much not to be right. I don't want a defective model. Any help would be greatly appreciated
I've posted photos to the above page of my new Blichmann Top Tier burner. I noticed it is missing one of the four screws that attach the burner to the frame. Not a big deal as long as they send me a replacement screw. Here is where my concern is, when I tried to use one of the other three screw in that hole it couldn't reach the burner because of the large gap between the round frame and the burner. Does anyone know if the burner should be flush to the frame or is there some wiggle room? I also found the the other screws to the burner were pretty loose. Has anyone else had to tighten up the burner when they got theirs new? I hate to have to send it back, but it cost too much not to be right. I don't want a defective model. Any help would be greatly appreciated