Ok so I have been racking my brain trying to decide which way to go on this. I am going to be using a 5500w or 6000w element for my brew kettle and am trying to decide if I should buy a 100qt aluminum pot which I can get for $70 shipped and then use all weldless fittings or find a good priced stainless pot and use the dimple/solder fitting technique a bunchf you guys are doing.
One reason I really want to go stainless is so I can have a nice bottom drain. Not possible with an aluminum and weldless fittings without leaving like an 1" of fluid on the bottom.
I've been looking all over but whats the BEST price you guys are finding on 80-100qt stainless pots? I don't need a triclad bottom becuase Im going electric.
Thanks for any info or advice you can lend
Mark
One reason I really want to go stainless is so I can have a nice bottom drain. Not possible with an aluminum and weldless fittings without leaving like an 1" of fluid on the bottom.
I've been looking all over but whats the BEST price you guys are finding on 80-100qt stainless pots? I don't need a triclad bottom becuase Im going electric.
Thanks for any info or advice you can lend
Mark