Actually, watching your video reminded me why I hate propane torches so much. I can now do that with MAPP gas (the yellow bottles) torch in about 10-15 seconds start to finish what you showed in 30 seconds sped up faster than realtime. Propane also tends to dry out the flux before the metal is hot enough to start wicking the solder into the joint because you are applying the heat for so much longer... thus a higher failure rate on your joints (especially for noobs)Cool Jay, let me know how much water leaks into your wort. I was lying about knowing how to sweat pipe, I just watched Norm Abrams do it on TV once ;-)
MAPP gas is the shizzle, so all you DIY folks don't bother messin' round with the propane. :rockin: