Mozart
Well-Known Member
Hello everyone!
I have one of those little mini-kegerators, and my CO2 regulator leaks. I've called the manufacturer, and they've sent me three replacements, and they all leak from the exact same spot as well.
I'm guessing I'm missing something extraordinarily simple, only I don't know what it is!
There's a tiny little threaded hex nut on the part of the regulator that screws onto the CO2 canister, and the regulators are leaking from there. I did manage to find something to try to tighten and/or loosen it, but that didn't seem to work (aside from the fact that my wrench set didn't have the right wrench, but I'll buy one gladly if I can get this to work). The little part will unscrew all the way out as well.
Any suggestions? A tiny bit of teflon pipe tape in there or something? The thing's so tiny it might be hard to get some in there, but I'll try just about anything.
Below is a picture of the regulator, if that helps.
I have one of those little mini-kegerators, and my CO2 regulator leaks. I've called the manufacturer, and they've sent me three replacements, and they all leak from the exact same spot as well.
I'm guessing I'm missing something extraordinarily simple, only I don't know what it is!
There's a tiny little threaded hex nut on the part of the regulator that screws onto the CO2 canister, and the regulators are leaking from there. I did manage to find something to try to tighten and/or loosen it, but that didn't seem to work (aside from the fact that my wrench set didn't have the right wrench, but I'll buy one gladly if I can get this to work). The little part will unscrew all the way out as well.
Any suggestions? A tiny bit of teflon pipe tape in there or something? The thing's so tiny it might be hard to get some in there, but I'll try just about anything.
Below is a picture of the regulator, if that helps.