I had put my schwartz beer in a keg for its last few weeks of lagering to free up a carboy. I hooked the gas line on and beer came squirting out of the liquid side down at the base of the nut. Not a big deal I racked it over to another keg but I couldn't get the lid to seal, or any other lid I tried. So I racked it to a third keg and all is well. My quick easy swap turned out to be a long night of chasing beer around.
I think I may have broken the liquid side post by using an adjustable wrench on it. So to insure that doesn't happen again I'd like to grind down a socket to fit over the pin locks. Does anyone now what size socket I would need?
Thanks
I think I may have broken the liquid side post by using an adjustable wrench on it. So to insure that doesn't happen again I'd like to grind down a socket to fit over the pin locks. Does anyone now what size socket I would need?
Thanks