kasky99
Well-Known Member
So due to the different types of threads used in Japan VS the united states I was forced to buy a new nut for my pressure regulator. I have been trying for the last two hours to try and remove the co2 inlet on the pressure regulator. So far all I have managed to do is nearly round out end of the stem with a wrench and it has nut budged at all. The gasket at the end is now slightly cracked and I am so pissed off I am about to smash the thing with a hammer. Yes I understand that it is a left hand loose thread so no I have not been sitting here tightening it. Can anyone give me any suggestions/help with this? I am pretty sure all I have managed to do it turn my regulator into a doorstop.