strat_thru_marshall
Well-Known Member
I just got my stainless tubing for my stand build.
Is there any reason that I should not use a 10" miter saw with an abrasive cutoff blade to make my cuts? it's 2" 11ga stainless square tubing
I have seen recommendations of using a bandsaw for tubing, but I dont have a bandsaw.
I have learned the entirety of my DIY skills from this forum and my brewhouse builds...thanks in advance!
Is there any reason that I should not use a 10" miter saw with an abrasive cutoff blade to make my cuts? it's 2" 11ga stainless square tubing
I have seen recommendations of using a bandsaw for tubing, but I dont have a bandsaw.
I have learned the entirety of my DIY skills from this forum and my brewhouse builds...thanks in advance!