TriggerDog
Member
Brutus Build Valve orientation question
So I am now doing the final assembly of my Brutus clone and I wanted to know if any one has an opinion or recommendation for valve orientation. I see that most build have the vales right after their pots/keggles and then the tee with the thermowells and disconnects. I was thinking of putting the valve pointing downward after the tee. I have attached a link to a picture to show the different. Any suggestion with which way is better or problems with the orientation? Valve down on the right, valve after pot of the left.
http://www.flickr.com/photos/50670140@N02/4655169650/
Thanks,
Mike
So I am now doing the final assembly of my Brutus clone and I wanted to know if any one has an opinion or recommendation for valve orientation. I see that most build have the vales right after their pots/keggles and then the tee with the thermowells and disconnects. I was thinking of putting the valve pointing downward after the tee. I have attached a link to a picture to show the different. Any suggestion with which way is better or problems with the orientation? Valve down on the right, valve after pot of the left.
http://www.flickr.com/photos/50670140@N02/4655169650/
Thanks,
Mike