Is it possible to replace my Single Tap 2.5" Draft Tower with a 2 Tap 3" Draft Tower?
Got a kegerator recently and the tower is a 2.5" and the flange is 3.5"
Could I get the 3" Tower with a 4.5" Flange and just drill new mounting holes? The Towers diameter will be about a 1/2" bigger than the hole in the top of the kegerator but that shouldn't be a problem right??
Got a kegerator recently and the tower is a 2.5" and the flange is 3.5"
Could I get the 3" Tower with a 4.5" Flange and just drill new mounting holes? The Towers diameter will be about a 1/2" bigger than the hole in the top of the kegerator but that shouldn't be a problem right??