Optimal
Well-Known Member
So I got around to building a manifold today, turned out decent and the wife was like "did you make this". She's useless when it comes to DIY... Just don't tell her I said that! Anyways, this is the second one I built. The first had the tubes running horizontal and just didn't look right. So I looked around on HBT and found a solution!
It's not complete, the cutting discs I have for my Dremal are ancient and very brittle. The last thing I want is pieces of disc in my face!
Any suggestions on how I could improve it, even if it requires rebuilding. I plan on fly sparging, and think this should work and doesn't promote channeling. But I am no expert! Also only the 3 center vertical pieces will be slotted.
Installed
Going to put a 1/2"x3/8"x1/2" "T" and run a piece of hose from the barb to the "T".
P.S Thanks to whoever gave me the idea. Sorry I don't remember who it was.
It's not complete, the cutting discs I have for my Dremal are ancient and very brittle. The last thing I want is pieces of disc in my face!
Any suggestions on how I could improve it, even if it requires rebuilding. I plan on fly sparging, and think this should work and doesn't promote channeling. But I am no expert! Also only the 3 center vertical pieces will be slotted.
Installed
Going to put a 1/2"x3/8"x1/2" "T" and run a piece of hose from the barb to the "T".
P.S Thanks to whoever gave me the idea. Sorry I don't remember who it was.