I recently purchased the Avanti BD-6000 Kegerator so I would be able to utilize commercial Sanke kegs as well as cornies. After inserting my first commercial keg, I noticed a huge problem. The clearance from the top of the sanke tap and the top of the kegerator was only barely enough to allow the beer line to make the 90 deg turn. This situation precluded me from installing a barbed fitting or other type of adapter to allow the removal of the compression fitting that came preinstalled on the beer line. After much research I finally came across a low profile Sanke tap that will work perfectly.
If anyone else has the same issue check this out.
http://www.midwestsupplies.com/products/ProdByID.aspx?ProdID=6193
If anyone else has the same issue check this out.
http://www.midwestsupplies.com/products/ProdByID.aspx?ProdID=6193