AStrafaccia
Member
This is my first post :-D.
I have been searching for the answer and I can't find one. I built a keezer using the information found on this forum. I used a 7.0CF fcm7suww GE Freezer here are some pics
As you can see I built it to hold 4 kegs, because the internet said that model can hold 4, I've even seen pictures with it holding 4. But for some reason for my freezer its basically impossible to fit all 4 in. If I could get like 1/4"-1/2" I bet they would slide in really nice. I was noticing that the rubber foot of the keg is what is really jamming everything up, it bulges out a bit in all direction.
So my questions are:
1. Anyone know of a good way to cut that rubber? Just to make it thinner?
2. Is there a better way to make them all fit? Maybe use a mallet on the hump and dent it in?
I know that there is the option of buying a 3gal keg and putting it on the hump. But I would rather try some options before dropping the cash to do that.
I have been searching for the answer and I can't find one. I built a keezer using the information found on this forum. I used a 7.0CF fcm7suww GE Freezer here are some pics
As you can see I built it to hold 4 kegs, because the internet said that model can hold 4, I've even seen pictures with it holding 4. But for some reason for my freezer its basically impossible to fit all 4 in. If I could get like 1/4"-1/2" I bet they would slide in really nice. I was noticing that the rubber foot of the keg is what is really jamming everything up, it bulges out a bit in all direction.
So my questions are:
1. Anyone know of a good way to cut that rubber? Just to make it thinner?
2. Is there a better way to make them all fit? Maybe use a mallet on the hump and dent it in?
I know that there is the option of buying a 3gal keg and putting it on the hump. But I would rather try some options before dropping the cash to do that.