So I just finished up my new keezer. brand new 13cf Frigidaire with a love TS2-010 controller.
This controller came off my last keezer I had for over a year. All programming is the same. Got it all wired up and it started cooling nicely. About 2 hrs after I plugged it in, it hit target temp and now it will not shut off.
Hysteria is set to 2deg, and it is 10 deg below that now. Any ideas? Im 99% sure its wired up right. I heard the love controller relay click when it was 1degree below the set point. its very odd. any help would be much appreciated!
Could this be a safety override from the temp alarm? The thermocouple from the original thermostat is still attached as well. I figured this wolud have no bearing since you disconnect the switched hot side of the original thermostat. I just cant figure out how the compressor is getting power unless the controller is malfunctioning.
Thanks,
JP
This controller came off my last keezer I had for over a year. All programming is the same. Got it all wired up and it started cooling nicely. About 2 hrs after I plugged it in, it hit target temp and now it will not shut off.
Hysteria is set to 2deg, and it is 10 deg below that now. Any ideas? Im 99% sure its wired up right. I heard the love controller relay click when it was 1degree below the set point. its very odd. any help would be much appreciated!
Could this be a safety override from the temp alarm? The thermocouple from the original thermostat is still attached as well. I figured this wolud have no bearing since you disconnect the switched hot side of the original thermostat. I just cant figure out how the compressor is getting power unless the controller is malfunctioning.
Thanks,
JP