atchinator
Well-Known Member
I received a Blichmann Floor standing burner and I'm having problems igniting it.
I turn the gas on, I can hear it but the burner doesn't light and after a few seconds, Istart smelling propane everywhere.
I'm wondering if it's a problem with the cast of the burner itself. Right behind the air vent, the burner is kind of "clogged" up with aluminum. I took it apart and ran some water through it and only a very small trickle of water flow through.
Should there really be about a half inch hole/tube running all the way through the burner?
I turn the gas on, I can hear it but the burner doesn't light and after a few seconds, Istart smelling propane everywhere.
I'm wondering if it's a problem with the cast of the burner itself. Right behind the air vent, the burner is kind of "clogged" up with aluminum. I took it apart and ran some water through it and only a very small trickle of water flow through.
Should there really be about a half inch hole/tube running all the way through the burner?