While I wanted to go all electric, I am going to have to make some changes.
I am looking at building a small panel to control my HLT heating element. I am going to build it to display the temperature of the HLT and MLT. My BK will be heated by propane gas but will eventually use the natural gas since the pipe runs right behind my brew table/work bench.
Here is what I have figured out so far to buy:
(1) Auber Small Control Box
(2) Auber PID 2352
(1) Auber Contractor (is the ebrew.com version the same?)
(1) Auber SSR
(1) Auber Heatsink
(2) Auber RTD Deluxe Sensor
(1) 2 way switch
(1) Blue 120V Pilot Light
(1) Yellow 240V Pilot Light
(1) 7A - Inline Fuse
(2) 8 position terminal strip, 20 Amp
NEMA L6-30 female and male receptacles
Looking for suggestions and help. Thanks to Kevin already for helping me get going.
I am looking at building a small panel to control my HLT heating element. I am going to build it to display the temperature of the HLT and MLT. My BK will be heated by propane gas but will eventually use the natural gas since the pipe runs right behind my brew table/work bench.
Here is what I have figured out so far to buy:
(1) Auber Small Control Box
(2) Auber PID 2352
(1) Auber Contractor (is the ebrew.com version the same?)
(1) Auber SSR
(1) Auber Heatsink
(2) Auber RTD Deluxe Sensor
(1) 2 way switch
(1) Blue 120V Pilot Light
(1) Yellow 240V Pilot Light
(1) 7A - Inline Fuse
(2) 8 position terminal strip, 20 Amp
NEMA L6-30 female and male receptacles
Looking for suggestions and help. Thanks to Kevin already for helping me get going.