rono73
Well-Known Member
I've done my second All Grain now, and I want to try rigging up a better sparge system. Currently, I've been getting my sparge H2O up to temp, and then using my auto-siphon to rinse the grains. It's nice low-pressure, but it's too manual for such a long sparge.
I'm thinking about rigging up a few shower heads using the same system. I haven't seen any DIY plans from anyone on the forum, but I figure someone has done something like this. I also want to try to get my system to spin slowly for better coverage, but I don't know where to start with motors.
Any ideas are welcome, but the simpler the better. Cheers!
I'm thinking about rigging up a few shower heads using the same system. I haven't seen any DIY plans from anyone on the forum, but I figure someone has done something like this. I also want to try to get my system to spin slowly for better coverage, but I don't know where to start with motors.
Any ideas are welcome, but the simpler the better. Cheers!