Thundercougarfalconbird
Well-Known Member
- Joined
- Dec 16, 2010
- Messages
- 760
- Reaction score
- 25
I'm planning on setting up one kettle with a 120v element based on Kal's Electric Brewery design. Thus buying a lot of this stuff new would cost a significant amount, so I'm trying to get the scraps of peoples finished rigs. I need the following:
1x Weatherproof 2-gang outlet box with at least one 3/4" FPT access hole
2x Weatherproof 2-gang blank cover & gasket
4x #6-32 machine screw hex nut
4x #6 locking washer
1ft 3/4" heat shrink tubing
3x 10 AWG wire ring terminal (I may just solder them instead, but if you have spares I'd use em)
10ft 1/2" expandable braided sleeving
1x Silicone high temperature o-ring (1-3/16" ID x 1-7/16" OD x 1/8" width)
1x Food grade silicone adhesive/sealant (Can be used as long as there is enough for the one seal)
1x Stainless steel washer/shim (0.075" thick, 1-1/2" ID, 2-1/4" OD)
1x Standard straight cord/wire grip, 3/4" NPT (For cord diameter .50" to 0.63", aluminum, -30F to +225F)
1x Stainless steel locknut 1" NPS
1x 1-1/4" round chassis or radio (not conduit!) punch OR Step Bit with 1-1/4 size on it (Cheap bits are fine I just need it for this project)
1x 2-1/4" bi-metal hole saw for making 2-1/4" diameter holes (with Pilot hole drill thingy)
1x metal file
1x Heat gun
I know its a pretty large list. But bear with me if you can help me out.
Thanks for your time,
-TCFB
1x Weatherproof 2-gang outlet box with at least one 3/4" FPT access hole
2x Weatherproof 2-gang blank cover & gasket
4x #6-32 machine screw hex nut
4x #6 locking washer
1ft 3/4" heat shrink tubing
3x 10 AWG wire ring terminal (I may just solder them instead, but if you have spares I'd use em)
10ft 1/2" expandable braided sleeving
1x Silicone high temperature o-ring (1-3/16" ID x 1-7/16" OD x 1/8" width)
1x Food grade silicone adhesive/sealant (Can be used as long as there is enough for the one seal)
1x Stainless steel washer/shim (0.075" thick, 1-1/2" ID, 2-1/4" OD)
1x Standard straight cord/wire grip, 3/4" NPT (For cord diameter .50" to 0.63", aluminum, -30F to +225F)
1x Stainless steel locknut 1" NPS
1x 1-1/4" round chassis or radio (not conduit!) punch OR Step Bit with 1-1/4 size on it (Cheap bits are fine I just need it for this project)
1x 2-1/4" bi-metal hole saw for making 2-1/4" diameter holes (with Pilot hole drill thingy)
1x metal file
1x Heat gun
I know its a pretty large list. But bear with me if you can help me out.
Thanks for your time,
-TCFB