Formito
Well-Known Member
So Im thinking using a 1/4" ID copper pick up tube on a compression fitting in the mash tun. I want to have it long enough to end in the center of the tun(rectangular cooler).then use a 1/2" braided SS tube along the length of the copper to the edge of the cooler.
The purpose of this would be to eliminate the dead space in the tun while still allowing it to drain in the traditional way. My bulk head is about 1.5" above the base so I have significant draining issues.
Is this doable? My current system is a PEX nightmare and I want to try something different with less dead space.
The purpose of this would be to eliminate the dead space in the tun while still allowing it to drain in the traditional way. My bulk head is about 1.5" above the base so I have significant draining issues.
Is this doable? My current system is a PEX nightmare and I want to try something different with less dead space.