So I am going to buy some flex watt heat tape to rig to a temp controller for a sanke keg. I know if you get the 11 inch its pretty much a fermwrap.. but I dont think it would tape onto a sanke fermenter well because of the shape.
My solution is to get 4 feet of the 3 inch. It says that 1 foot of 3 inch is 10 watt.. so 4 feet would be 40 watts of heat getting put into the keg. I can just tape the 3 inch strip around the entire keg.. then just put the probe above it or to measure temp.
Would this be sufficient for an 11 gallon batch? Ive never used the stuff before. Ive been researching it on here and through their site and I think it will work but I just thought Id ask.
My solution is to get 4 feet of the 3 inch. It says that 1 foot of 3 inch is 10 watt.. so 4 feet would be 40 watts of heat getting put into the keg. I can just tape the 3 inch strip around the entire keg.. then just put the probe above it or to measure temp.
Would this be sufficient for an 11 gallon batch? Ive never used the stuff before. Ive been researching it on here and through their site and I think it will work but I just thought Id ask.