loetz
Well-Known Member
I've been getting some weird readings from my rex c100s.
I'll set the 'set value' to 66, it will heat the water up to that level and then the 'present value' display will read as if it is holding a steady temp at 66.
Afterwards I'll raise the set value to 75, and instantly the present value temperature reading will increase dramatically.
I have no idea what is going on here. Do any of you know what it could be? I have some video of this happening in my later posts.
Here are a couple pics of my set up:
Note: I hadn't calibrated the temperatures yet in this picture, so that's why the PVs for the three PIDs are all reading different room temperatures. And, yes, I know the middle one isn't currently connected to an SSR.
I'll set the 'set value' to 66, it will heat the water up to that level and then the 'present value' display will read as if it is holding a steady temp at 66.
Afterwards I'll raise the set value to 75, and instantly the present value temperature reading will increase dramatically.
I have no idea what is going on here. Do any of you know what it could be? I have some video of this happening in my later posts.
Here are a couple pics of my set up:
Note: I hadn't calibrated the temperatures yet in this picture, so that's why the PVs for the three PIDs are all reading different room temperatures. And, yes, I know the middle one isn't currently connected to an SSR.