mlevings12
Well-Known Member
So I have been experiencing some issues since switching to BeerSmith. My water volumes always seem to generate more wort than expected. Additionally, my FGs have all been too high.
I am brewing all grain, however I do not have one large brew kettle. I use (2) four-gallon kettles, so I doubled my boil off rate to account for the increased surface level. Everything else is the same as when I was doing the water calculations by hand.
I'm wondering if maybe I'm sparging too quickly. I batch sparge.
Any insight is much appreciated.
I am brewing all grain, however I do not have one large brew kettle. I use (2) four-gallon kettles, so I doubled my boil off rate to account for the increased surface level. Everything else is the same as when I was doing the water calculations by hand.
I'm wondering if maybe I'm sparging too quickly. I batch sparge.
Any insight is much appreciated.