martink49
Member
I have always bottled my homebrews but recently invested in a corny keg setup. I have a brew ready to go into the keg. I sanitized the keg and was going to run some cleaning solution through the liquid out lines. I set the psi on the regulator to about 15 but I only get a small trickle of liquid through the tap. I swapped the posts and poppets with those from another keg with the same results. I believe the keg is pressurizing because the release valve does hiss etc.
Any ideas what the problem may be?
Thanks in advance!
Any ideas what the problem may be?
Thanks in advance!