So I just got a used Bayou Classic SP10 High Pressure 14" Dia. Outdoor Propane Gas Cooker (Seen in the picture below)
And I was worried about the flat base on the cooker and the Keg that I have (Soon to be Keggle) and how it would fit on the cooker with the rounded Keg bottom. And just as I thought, the 3 triangle pieces that jet out in the middle of the cooker base do not allow the Keg to lay flat and the outside of the keg is just a bit wider than the circular base of the cooker.
So I wonder if I just cut off the 3 triangle pieces that jet out in the middle that it would allow the Keggle set proper and comfortable on top.
Has anyone ran into this scenario with this set up? Any advise either way?
Thanks in advance.
And I was worried about the flat base on the cooker and the Keg that I have (Soon to be Keggle) and how it would fit on the cooker with the rounded Keg bottom. And just as I thought, the 3 triangle pieces that jet out in the middle of the cooker base do not allow the Keg to lay flat and the outside of the keg is just a bit wider than the circular base of the cooker.
So I wonder if I just cut off the 3 triangle pieces that jet out in the middle that it would allow the Keggle set proper and comfortable on top.
Has anyone ran into this scenario with this set up? Any advise either way?
Thanks in advance.