zstar5000
Member
This may be difficult to explain, but I have a ten gal Rubbermaid cooler that I use for my mash tun. I'm also about to install a pump to get the water from my kettle to tun.
The lid on my cooler appears hollow, and I want to get a fly sparge system going. I'm thinking about drilling a hole in the top/exterior of the lid in which to place the tubing carrying the water from the kettle. Then I'm thinking of drilling a series of small holes on the bottom/interior of the lid to create a drip system. The water would enter the top of the lid, and disperse throughout the hollow lid while dripping down on top of the grain. Anyone done anything like this before? Any initial red flags I haven't thought of? Thanks!
An
The lid on my cooler appears hollow, and I want to get a fly sparge system going. I'm thinking about drilling a hole in the top/exterior of the lid in which to place the tubing carrying the water from the kettle. Then I'm thinking of drilling a series of small holes on the bottom/interior of the lid to create a drip system. The water would enter the top of the lid, and disperse throughout the hollow lid while dripping down on top of the grain. Anyone done anything like this before? Any initial red flags I haven't thought of? Thanks!
An