well im getting some more stuff for xmas, and just need to double check if what im asking for is correct. right now this is my set up.
now i pretty much have decided to get another cooler (same size) for the HLT, and pump, and quick disconnects. now i just need you guys to make sure this is going to all work out .
pump March High Temperature Brewing Pump | MoreBeer
quick disconnects
female Brass Hose - Female QD | MoreBeer
male Brass Hose - Male QD | MoreBeer
ok, so now the questions. the male fittings will each thread into the valves in the kettle and coolers. now, does the hose connect to the female fitting in any special way? and about into the pump?
i imagine i also could use a ball valve on the outlet of the pump, do i need anything other than a nipple out of the valve?
i know i will need 3 males on the coolers and the kettle, and a female for the inlet to the pump and also one for the outlet, correct? anything im missing?
thanks for the patience in advance guys.
now i pretty much have decided to get another cooler (same size) for the HLT, and pump, and quick disconnects. now i just need you guys to make sure this is going to all work out .
pump March High Temperature Brewing Pump | MoreBeer
quick disconnects
female Brass Hose - Female QD | MoreBeer
male Brass Hose - Male QD | MoreBeer
ok, so now the questions. the male fittings will each thread into the valves in the kettle and coolers. now, does the hose connect to the female fitting in any special way? and about into the pump?
i imagine i also could use a ball valve on the outlet of the pump, do i need anything other than a nipple out of the valve?
i know i will need 3 males on the coolers and the kettle, and a female for the inlet to the pump and also one for the outlet, correct? anything im missing?
thanks for the patience in advance guys.