broadbill
Well-Known Member
Hi-
I just procured a keg that I am planning to convert into a keggle. In bringing the keg home, I realized that the the keg is a bit too wide to sit on my turkey fryer burner. My burner has a ring welded to the housing that acts as a guard to prevent a pot from tipping off of the burner. I've never seen a burner like this one before.
Has anyone had a similar problem and what did you do to fix it? The obvious answer is to cut the ring off, I'm just throwing it out there to see if anyone had a more clever workaround.
Thanks!
I just procured a keg that I am planning to convert into a keggle. In bringing the keg home, I realized that the the keg is a bit too wide to sit on my turkey fryer burner. My burner has a ring welded to the housing that acts as a guard to prevent a pot from tipping off of the burner. I've never seen a burner like this one before.
Has anyone had a similar problem and what did you do to fix it? The obvious answer is to cut the ring off, I'm just throwing it out there to see if anyone had a more clever workaround.
Thanks!