So I am not a welder by trade but have taken some classes and been welding for a couple years now. Did some research and found if I wanted to turn some kegs into keggle I needed to back purge. Lincoln TIG185 set to 85 amps (not really going full throttle though) and using 1/16 316 rod.
So I tried the can and second hose method and I am not sure it work very good. So the that is the first one, it is not black so not 100 percent it is surgaring. The second one was black as the tape let lose and I didnt know it and the can was half hanging off.
So I was going to use this for HLT so not sure how critical it is, can I still use it? Also I still need to do my BK and my buddies BK if I can get this squared away. Please let me know what you guys think so I can maybe figure what went wrong so I can try again.
So I tried the can and second hose method and I am not sure it work very good. So the that is the first one, it is not black so not 100 percent it is surgaring. The second one was black as the tape let lose and I didnt know it and the can was half hanging off.
So I was going to use this for HLT so not sure how critical it is, can I still use it? Also I still need to do my BK and my buddies BK if I can get this squared away. Please let me know what you guys think so I can maybe figure what went wrong so I can try again.