SurlyBastard
Active Member
Certainly jealous, I can't convince the wife to go AG yet because we do not have the space. But someday soon I will be in your same shoes with a brew in my hand and brewing my first AG on my own setup ^^
Fantastic build Schweaty !
You did an awesome job here !:rockin:
Where did you use the half couplings and where did you use the full? I'm getting ready to build 3 new keggles and I need some ideas.
Shweaty, that is sweet setup. Do you have plans drawn up for your frame? I am about to have one built and I like yours, a lot.
Thanks...
Nice job! Did you mig this? What wire/gas did you use?
Post #31 has the cuts for the stainless and the burner bracket dimensions. I used to have sketchup documents but I think I trashed them after the build was complete.
very nice... I can't believe how quickly stuff adds up.
-=Jason=-
Schweaty,
I know that March recommends that the inlet side of the pump face down with the outlet facing up, which is the opposite of how your pumps are configured. It's counterintuitive, but they say it helps with prime. Do Chuggers not recommend the same configuration?? Maybe it doesn't matter as much since Chuggers are self-priming??
Just curious....I'm putting together a recirculating single-vessel BIAB RIMS stand right now, so I've been researching a ton lately.
[...]Maybe it doesn't matter as much since Chuggers are self-priming??[...]
Enter your email address to join: