madcow_number_6
Well-Known Member
- Joined
- May 28, 2010
- Messages
- 91
- Reaction score
- 1
Going to try my hand at All-Grain Brewing with my next batch. Probably a Stout. I've read up on Batch Sparging and it seems like it will work good for me without my having to buy more equipment.
I've scored a nice sheet of Perforated Stainless from work(was the outer sheath on an oil filter) to make a False Bottom with. The holes in it are 3/16 around and 1/16 apart...
Is this going to be a fine enough mesh to avoid problems mid sparge? There is enough of it that I can make 5 or 6 False Bottoms for my five gallon cooler, so I can double up on one if I need to reduce the openings.
I've scored a nice sheet of Perforated Stainless from work(was the outer sheath on an oil filter) to make a False Bottom with. The holes in it are 3/16 around and 1/16 apart...
Is this going to be a fine enough mesh to avoid problems mid sparge? There is enough of it that I can make 5 or 6 False Bottoms for my five gallon cooler, so I can double up on one if I need to reduce the openings.