Putting the parts together for my brewstand build. I really wanted the 10" banjos but tired of waiting for them to come back in stock at agrisupply and they are way more expensive everywhere else. From what I have been reading it seems the low pressure 6" ones are more than capable of 10 gallon boils.
Also to my understanding the added benefit of going low pressure is that down the road I can automate much cheaper.
So 3 of these burners.
http://www.agrisupply.com/burner-cast-low-pressure-multi-hole-btu-dia/p/40282/
And then one low pressure reg coming off the tank and supplying a black pipe fuel rail via a lp hose.
http://www.agrisupply.com/low-pressure-regulator-soft-nose-wheel-pol-hand/p/33735/
http://www.agrisupply.com/high-pressure-hose-assembly-mpt-ffl/p/36108/
From there I will have 3 needle valves off the rail to each burner with either more custom length gas line or soft copper.
I just want to make sure that 1 low pressure reg will supply enough gas. There may be times when I will have 2 burners going full, as I occasionally do back to back brews. Also want to confirm that these burners configured this way will get me to boil in a good time frame. Right now im using small turkey fryer stands that have the small high pressure burners and i do fine with them but they are loud and seem to not be very efficient.
Lemme know if this will work.
Also to my understanding the added benefit of going low pressure is that down the road I can automate much cheaper.
So 3 of these burners.
http://www.agrisupply.com/burner-cast-low-pressure-multi-hole-btu-dia/p/40282/
And then one low pressure reg coming off the tank and supplying a black pipe fuel rail via a lp hose.
http://www.agrisupply.com/low-pressure-regulator-soft-nose-wheel-pol-hand/p/33735/
http://www.agrisupply.com/high-pressure-hose-assembly-mpt-ffl/p/36108/
From there I will have 3 needle valves off the rail to each burner with either more custom length gas line or soft copper.
I just want to make sure that 1 low pressure reg will supply enough gas. There may be times when I will have 2 burners going full, as I occasionally do back to back brews. Also want to confirm that these burners configured this way will get me to boil in a good time frame. Right now im using small turkey fryer stands that have the small high pressure burners and i do fine with them but they are loud and seem to not be very efficient.
Lemme know if this will work.