I'm getting started on a new electric BK. I picked up a keg and it's rubber coated. I want to make this one bottom draining with a tri clamp.
I'm wondering if the rubber can handle boil temps? It is stainless inside.
I hear the stainless is thinner on these kegs. That won't matter, will it?
Any tips for cutting the rubber off where I want to drill my element holes and cut the bottom off? Thanks. I was going to use an angle grinder with a cut off wheel.
I'm wondering if the rubber can handle boil temps? It is stainless inside.
I hear the stainless is thinner on these kegs. That won't matter, will it?
Any tips for cutting the rubber off where I want to drill my element holes and cut the bottom off? Thanks. I was going to use an angle grinder with a cut off wheel.