dutch101st
Well-Known Member
I am looking for a source for a sight tube to put in line of my recirculation line...primarily on the "out" on my MLT valve
Any suggestions?
Any suggestions?
Hey if you that well off, i'd be happy to let you finish funding MY build as well just thought i'd offer......I will see about what I can come up with...if not, I can lay the cash out...I do fairly well
Hey if you that well off, i'd be happy to let you finish funding MY build as well just thought i'd offer......
9176T32 is 3/4" OD, 5/8" ID. You could use the 1/2" OD stuff also, but then you're down to 3/8" ID.
A Tri Clamp borosilicate glass sanitary sight glass is $66 bucks at St Pats. That would be hard to beat as even the buying two 3/4" swageloks would be at least half that.
You can sometimes snag compression fittings for a few bucks on Ebay. No reason to buy them retail from Mcmaster.com
Enter your email address to join: