Hey Guys,
So im in the process of putting together a eHerms system. My kegs themselves are pretty much done, now its time to put together the electronics. Ive purchased most of the stuff but would like to get some feedback on this circuit before I actually begin.
This is a mix of TiberBrew and Kals posts...so a big thanks goes out to them and others who have helped along the way!
Circuit
****The red arrows are junctions which I am not confident about. Can these join or should they individually reach the BUS...???
Front Panel
Bottom Panel
Thanks!
Gabrew
So im in the process of putting together a eHerms system. My kegs themselves are pretty much done, now its time to put together the electronics. Ive purchased most of the stuff but would like to get some feedback on this circuit before I actually begin.
This is a mix of TiberBrew and Kals posts...so a big thanks goes out to them and others who have helped along the way!
Circuit
****The red arrows are junctions which I am not confident about. Can these join or should they individually reach the BUS...???
Front Panel
Bottom Panel
Thanks!
Gabrew