dood56
Active Member
I just brewed my first and am going to be building my keezer this weekend. However, I have run into an issue and I am not sure what to do. I put the gas and liquid disconnects on to my keg and on the proper peg. However, when I went to carb the beer, I didn't have anything on the output side and beer came shooting out of it. Pretty funny to the experienced I am sure. So I went to take off the liquid disconnect and it will not come off. I tried the same on the gas side and I can't get it off either. It was my understanding these were designed to be able to be pulled straight off. My keg is not pressurized either. I would really like an answer quickly since my beer is just sitting in the open now. I appreciate any assistance.