OK, now I have a new problem.
I am finishing the build of a brutus 10 stand. I am using (3) 23 tip jet type burners from Top Food service, that I have plugged to only use 10 tips.
System is configured for L.P propane, low pressure regulator on the propane tank.
I tried to fire up one of the burners the other day, and I could only get one of the 10 jets to light on the burner.
I tried a high pressure regulator and all the jets fired, blue flame at bottom, tipped with yellow, about 3 - 4 inches high. However, the gas vlaves that I have from honeywell, I have been told can be damaged by high pressure.
So I re-connect the low pressure regulator to the propane tank, and it goes back to not wanting to light all the tips.
Things I have done to try to correct problem.
1) Checked for leaks, none located.
2) Swapped regulator with ANOTHER new LP regulator, same problem,
3) Called place where I got the burners, they ASSURED me, after they checked, that I did indeed have the proper LP burners, and not a NG burner.
At this point, I am lost, and need help trying to figure out what the problem is. ANY help would be greatly appreciated.
Thanks
Josh
I am finishing the build of a brutus 10 stand. I am using (3) 23 tip jet type burners from Top Food service, that I have plugged to only use 10 tips.
System is configured for L.P propane, low pressure regulator on the propane tank.
I tried to fire up one of the burners the other day, and I could only get one of the 10 jets to light on the burner.
I tried a high pressure regulator and all the jets fired, blue flame at bottom, tipped with yellow, about 3 - 4 inches high. However, the gas vlaves that I have from honeywell, I have been told can be damaged by high pressure.
So I re-connect the low pressure regulator to the propane tank, and it goes back to not wanting to light all the tips.
Things I have done to try to correct problem.
1) Checked for leaks, none located.
2) Swapped regulator with ANOTHER new LP regulator, same problem,
3) Called place where I got the burners, they ASSURED me, after they checked, that I did indeed have the proper LP burners, and not a NG burner.
At this point, I am lost, and need help trying to figure out what the problem is. ANY help would be greatly appreciated.
Thanks
Josh