Search results

Do you have C23 with 24V control available?

FF wasn't refreshing fast enough for me either.

I do run run in manual/off/auto (bcs) mode with my switches. I think you're missing the pieces recommended for safety with using the SSRs and Contactors while working with high voltage.

I'm looking for help or guidance as to how to fine tune my BCS probes. Currently with default settings I show about a 4-5 degree variance as well as my temp readings off between 7-10 degrees. The probe on my BK shows 203 for a rolling boil. When I ran another test. I set my HLT at 125...

I've been using LWD elements also w/o problems.

I like having a manual control switch on the box w/o having to use th EPO. Because no matter how fast you are on the web interface it takes just a few seconds longer to apply and update before the change takes effect.

Almost all the info you need can be downloaded from their site. Take the enterance exam once for practice and take quick notes on the content and what to study. #1) Define every keyword listed on the scoresheet for section. malt, hops esthers ect. #2) Be descriptive, personal perceptions or...

I haven't had an issue with flow with my two pumps, including one sized from 3/4" down to 1/2" before the QD.

I also used an old computer case and sealed all the seams.

What's your overall length that you need? I have about 50' left of my roll. Maybe we could work out a deal.

Also remember your load. I did #2 with 50A in main box with a 50A GFI spa panel. The different in cost is only a couple bucks, to increase your overall cap.

Minnesota Homebrewers has an upcoming meeting next week. Checkout the site: http:\\mnbrewers.com

I'm guessing a few more now.

I picked up a dozen each of male and female connectors and converted everything for my setup over to them. I haven't had a leak yet and love them!

These are the same devices everyone uses for their 2 stage ferm chambers.

It's a standard P-J dual 5500W 240V + 2 120 outlet diagram. Only difference is I had a DPDT switch in front of the SSR for the control source. That the start of the this post was to find a lamp that would light on the BCS control signal. Instead now we're moving the lamp further down the...

Moved the lamp to after the contactor didn't help as some as the contactor closed the lamp lit, until one of them already failed... I moved everything around if the pump is in series it's out. If the contactor, with or w/o the kettle plugged it. It says lit. Very odd. Tested this with all five...

That's easy enough to try. It appears just having the pumps plugged into the AUX outlets with contactors is enough to make the leakage either go away or be reduced enough to not light the lamp.

Thank you for the help. I took the recommendation and moved the lamp to output side on the SSR. However I ran into an issue. 1/2 of SSRs are leaking enough voltage while in the OPEN state to light the lamp. The two on my pumps work normal but the two for my kettles are lit 100% of the time...

I have added pureed apples and cinnamon to my secondary of a pale ale. Midwest has an Apple Ale Kit you can buy.