Search results

:ghostly:

I would recommend the 20lb tank. One, most gas supply places will swap out tanks rather than filling them, so no need to get a fancy shiny 5lb tank when they will likely swap with an ugly steel tank. Two, the 20lb tanks obviously last much longer between fills. And C, price per pound is usually...

Thanks guys, I am going to give the LP route a shot, eventually. I ended up brewing this weekend using the HP setup and 20 lb tanks. It’s certainly doable for now, while I slowly gather up everything I need to make the conversation.

I set it to PT since it said that that was the default. It was on Cu50. I checked it in ice water, read 32.5 degrees. I am now heating up water to run the auto tune.

Thank you! That did it! My input sensor type was wrong. Reading within parameters now. Time to get it calibrated.

I have the manual, and I’ve tried to figure out the settings. I’ve watched YouTube videos on how to set it up, and while they certainly help none seem to have the issue I’m having. It seems that the input value is not calibrated correctly, or I have a wrong input value somewhere that I’m missing.

Thanks, probe is fully seated. Unfortunately it’s been sitting in the box for over a year, so out of warranty. Unfortunately I never got around to installing it until last night.

I set up my Inkbird controller last night for the first time. I am using it to control a RIMS tube. Whenever I get it powered on, the PV reading is way too high. When running 140 degree water through the RIMS tube, not powering the element, the controller is reading the temp in the 7-800 range...

Little background: I currently have a 2 burner stand, each burner has a 10 psi adjustable regulator on it, that I hood each to a separate 20 lb tank. The burners are typical 10" banjo burners. They are firing under keggles, and I typically brew 5 gallon batches, although I may possibly jump to...

Jay, I may need one of these sparge arms as well, but without the bend in the arm. I have a bulkhead for a cooler lid, but need to have the arm “hang” from the center of the lid. 1/2” diam.

Still got the refracto & hop filter? edit: Shoot just realized this was a post from July :no:

Just want to add that I have this, with 4 probes and it has been rock solid! I use both for smoking meat, and for checking mash temps. Different probes obviously!

Congrats to the winners! Looking forward to hearing a review on it!

USA - Love the InkBird products!

Count me in.

Which Meguiars did you use? I just tried the same concept, but used Mothers Mag polish instead of Meguiars. It came out OK, but wasn't truly satisfied, so I ordered some M100. Hopefully that will have more cut than the Mothers.

I'm going to be doing both myself. I was able to score a deal on superstrut when the local Lowes was clearing it out. It was the green powdercoated strut priced at $0.98 per 10' stick. I grabbed all they had - 15 sticks! :ban: I am going to cut it up and weld it to keep my costs at a minimum...

Thanks! Just after I placed my order :tank:

When do you think you'll have more "Pull Through Bulkhead Install Tools" in stock? Looking to convert a few kegs to keggles.

I'd give it a whirl!