Search results

Thanks. I bought a 1/4 keg and haven’t been drinking all that much lately. So may be a while for the change…

Hi Eberyone. New to kegerators. I have one line and don’t drink from it often but have had a keg (lager) on for about a month. How often would you recommend to clean the line? Would 6 weeks be ok? Also how often will the beer in the keg last. Need to drink more often :) Thank you.

Thank you very much. The chart with the co2 has helped. I lowered it to 8 psi, seems better. I also notice the first pour if dumped will result in less foamy beer thereafter. Remember doing that a few times in the past when filling from a keg. I do notice a decent amount of bubbles in this...

Thanks for taking the time to reply. I’ll be heading to hardware store tomorrow. Unsure the length it is the standard one from one of the major kegerator / beer sites. When the co2 went down the foam stopped but ultimately so did beer flow.

Hello This is all new to me and having some troubles. Thanks for you help. I attached the regulator to the co2 tank the regulator had a washer and a threaded end. Tightened with a co2 wrench. I attached the beer, and set the regulator to 10 psi, however I am having lots of foam. Wanted to...

Thanks for your note. I have attached a photo of the tap. There is two lines and having trouble running the two lines through. Is it possible to disconnect the lines from where the beer is drafted?

Thanks. Unsure if that is an option. Also tried to run two beer lines down thru the pipe and they don’t seem to fit. May need to go with pvc

Thanks to you both for your help. Would you suggest silicone or the goop product to seal it? I’m a bit concerned with screwing into the kegerator as there are no pilot holes and I would be screwing directly into the unit. Are there any other suggested ways to usually do this if I didn’t have...

Thanks everyone. Took a few more pictures. The metal tube ideally would go from inside the kegerator upwards however it doesn’t acrew into the plastic housing. I have been told it is ok to use self tapping screws and go right into the metal of the kegerator. Doesn’t seem ideal. The draft tower...

Thanks for your help. Have attached three photos. One from inside the kegerator, one outside of kegerator (counter top being installed shortly) and the piece that was provided with the kegerator but doesn’t seem to work.

Hello Thanks in advance for your help. I have a new kegerator and will be below a countertop. I have seen a few suggestions but unsure the best route to insulate the gap between the kegerator and the tap between the countertop. The kegerator came with a cooled system that looks like a chimney...