Search results

Hi DuncB. Thanks for the detailed posting. I have a 35L Brewzilla 3.0 and am considering adding insulation to the base, under the elements and above the electronics. I noticed the unit in the video has this. What type of insulation is appropriate? Has anyone added insulation below the...

Still available?

I am interested in the brewer’s edge mash and boil and the chiller.

Sent message via 'start conversation'

Hi Craig, Are the wort chiller and brewers edge mash and boil still available?

As time has passed would you consider selling the inkbird ipb-16 separately?

I am interested in the inkbird. Is it still available?

I coated mine in heat shrink tubing around 10 years ago. They are still working 100 batches later.

What is the firmware version? What ATMega chip is installed on the v3.3 BT board?

What model is the Auber thermostat?

I have an old brewtroller board that is not working properly. I am interested in a replacement. Do you have an unused bcs-460 or brewtroller controller?

OK. I understand that safety issue. If the switch is on the high voltage side of the SSR, it can kill the downstream device it is controlling in the event of SSR failure. A switch on the low voltage side does not offer the same control and protection in the event of failure.

I am trying to design my first electric system and appreciate the extensive knowledge of this forum. I would like to use a brewtroller or BCS-460(2) to control a 30amp, two kettle, two pump setup. I would like the controller to manage both elements and pumps via SSR. Most schematics that...

I know this was a long time ago but I am looking for a 20 gallon aluminum pot. Is anything still available?

Brewing for friends wedding. I need a bigger kettle! I am located in SE Pennsylvania. Please send me a PM if you know of something. Thank you.

I am interested in the wort chiller and live about 1 hour from Harrisburg. Can I arrange pickup?

Load the tubes and fill the gaps.... Big difference. Notice the clutter is gone, there is still extra space and there are 2 more kegs in the keezer! Each tube can hold 5 - 12 ounce bottles. I can fit two tubes in the gap areas so this means 10 bottles per gap. I also was able to...

I bought 5 - 4" PVC caps and a 10' PVC drain. Here are the PVC components. Construction: I cut the PVC pipe into 2' sections and glued the caps on. I drilled a few holes in the PVC to allow moisture to escape. 5 Keezer Tubes:

Dead space and clutter alll but gone. Before: Some gaps: and the clutter (yeast cultures, bottles, sanitizer, wort, hops, etc...)

Gap reclaimed