Search results

Look for a honey siv. Mine is 12" diameter and has retractable arms.

@Ozarks_Mountain_Brew the Anvil Foundary is double-walled. While your solution would work for a standard kettle there would need to be a specific solution for the Anvil Foundry so that the weldless fittings can seal against the inside wall while passing through the outside one. Hence Bobby's...

Are those the extended bulkheads from brewhardware?

Sign me up!

Yes, I reached out to them and Bobby said that would likely work. I think the trickiest part is making sure to have the right sized bit that's constructed in a way that allows it to pass through the outer hole to drill through the inner wall.

Has anyone successfully added a sight glass to the anvil foundry? It's double walled. The way I boil is a bit different and I need to track my volume in a better way the the internal markings. I know brew hardware has extended bulkheads. Maybe just a 7/8 hole saw with an extension?

The steel head has threaded ports instead of barbed, allowing the use of quick disconnects. I do like the clamp, though.

I just ordered the 6.5 gallon with recirculation kit and I'm going to find the same thing. Any luck? EDIT: I searched a lot to find this thread. No more than a minute later I found out anvil had one. Stainless Steel Pump Head for the Anvil Brewing Pump

I'm brewing 3.5-4 gallon batches and I will be making a jacket for my kettle as well. I figured that would be a good compromise for the time being. I might be able to get onto a 240v circuit but it would require a big investment in a substantial extension cord. It may still happen, but my house...

I could go with a weaker element if it's safer but I'd like to keep it as high as possible.

Thanks for the reply! You sold me on the EZBoil. I was leaning that way anyway. Would the EZBoil run the element at 100% in mash mode? I would only set it to 100% when rising to a boil then back it off a bit once I get there. I wouldn't be recirculating anymore at that point. I would have to...

Hello, everyone! I'm new to homebrew talk but I've been brewing for about 2 years and it's time for an upgrade! I've been researching a DIY controller. The setup I'm going for is a single vessel eBIAB, one pump for recirculation/counterflow chilling, 20a 120v power, 2250w heating element. I have...