I have been considering purchasing a plate chiller and a pump but have a stupid usage question that I need to get out of the way before I go ahead with the purchase.
How do people go about making sure none of the break material gets into the fermenter? Maybe my confusion is hung up on my current processes and how I would modify what I do to integrate a pump and plate chiller. Here's what I do with my immersion chiller today.
1. Sanitize immersion chiller in the last 5 min of my boil
2. Boil ends. Remove from heat and begin pumping water through chiller.
3. Usually have reached 70F more or less in 30-45 min
4. Whirlpool with sanitized spoon, cover brew kettle with lid while the whirlpool spins down (about 30 min)
5. Transfer to fermenter with auto-siphon.
My main point of confusion is how I would change this process if I added a plate chiller and a pump. Would I whirlpool warm/hot? How would I make sure the hop and break material stayed behind if I pumped from the kettle right after the boil?
How do people go about making sure none of the break material gets into the fermenter? Maybe my confusion is hung up on my current processes and how I would modify what I do to integrate a pump and plate chiller. Here's what I do with my immersion chiller today.
1. Sanitize immersion chiller in the last 5 min of my boil
2. Boil ends. Remove from heat and begin pumping water through chiller.
3. Usually have reached 70F more or less in 30-45 min
4. Whirlpool with sanitized spoon, cover brew kettle with lid while the whirlpool spins down (about 30 min)
5. Transfer to fermenter with auto-siphon.
My main point of confusion is how I would change this process if I added a plate chiller and a pump. Would I whirlpool warm/hot? How would I make sure the hop and break material stayed behind if I pumped from the kettle right after the boil?