Hi All- I have access to a few brand new motors from work, for free. They're pretty low power though, not strong enough to drive a mill or anything. Wondering if anyone has motorized any other brewing equipment.
The spec sheets for the motor can be found here:
http://www.msitec.com/vendors/MCG/PDF/ID23004.pdf
Basically, the specs are
4100RPM, 131W, 60V DC
Tcr = 2.7 lb-in
Tpr = 5.4lb-in
I'm at a loss but am always up for a little electrical/mechanical DIY. If not, I will have to find some other use for it:rockin:
The spec sheets for the motor can be found here:
http://www.msitec.com/vendors/MCG/PDF/ID23004.pdf
Basically, the specs are
4100RPM, 131W, 60V DC
Tcr = 2.7 lb-in
Tpr = 5.4lb-in
I'm at a loss but am always up for a little electrical/mechanical DIY. If not, I will have to find some other use for it:rockin: