Kyled93
Well-Known Member
Can anyone suggest a set of feeler gauges they use for adjusting their grain mill? I have been looking but can't seem to locate the size range. They are mostly all to small.
Grain mill feeler gauges?
- Thread starter Kyled93
- Start date
Help Support Homebrew Talk - Beer, Wine, Mead, & Cider Brewing Discussion Forum:
mosquitocontrol
Well-Known Member
I got mine at pep boys. They were all too small but you can use 2 that are right next to each other to get pretty close. I got one of the 25 or 25 blade ones.
.018+.019 = .037
.019+.020 = .039
So you can't get the .038 everyone's always spouting out. But I figure 1/1000th off won't hurt!
.018+.019 = .037
.019+.020 = .039
So you can't get the .038 everyone's always spouting out. But I figure 1/1000th off won't hurt!
mosquitocontrol said:
You can get .038. It is .018 and .020. Although these are not right next to each other, they are close enough to get .038 without bending the gauges.
Mark
I picked up mine at Harbor Freight. Cost like 4 bucks and has 30 some sizes
HDIr0n
Well-Known Member
That is what I did, works well for my mill.
Similar threads
