So I am able to get my hands a few kegs pretty cheap so I'm gonna make the jump to 10 gallon batches. First is the boil kettle I want to put on all the bells and whistles. So I've ordered some stainless fittings and I'm going to drill 3 holes to get a thermometer, spigot and sight tube. the first 2 I think are easy the next one is what giving me some fits. I have a couple stainless steel 3/8 half couplers that I want to use for the sight tube. Should I just buy this fitting or is there something cheaper? McMaster-Carr I was also planning on trying to use this tubing with the ferrel and some o-rings to seal it to the compression fitting. McMaster-Carr. Then the next question is I'm pretty set on a false bottom for the MLT so I was wondering whose got what in thier Sankeys? I'm leaing towards the northern brewer one and bending a piecs of tube to fit through the 1/2 inch hole. I looked at the sabco one and it seems pricey. Since I plan on heating the MLT is there anything besides a false bottom that wont scorch the grain? Sorry for the long winded post but I'm anxious to get it set up so I can get it all burned home