tomwirsing
Well-Known Member
- Joined
- Oct 2, 2008
- Messages
- 106
- Reaction score
- 2
The regulator I have (free CL acquisition), came with a bent set screw. I've used it successfully for a few brews. The bend in the screw allows me to turn the pressure up to around 15 psi. At 15, the bend keeps me from turning it further.
I'd like to be able to go to higher pressures to speed force carbing (I only have one corny at present, so when it's gone I have to wait for the next one to carb).
Please let me know if this is an easy repair or if I'm going to run into a mess by disassembling the regulator. If you can offer advice on how to perform this repair, I'd appreciate that as well.
I'd like to be able to go to higher pressures to speed force carbing (I only have one corny at present, so when it's gone I have to wait for the next one to carb).
Please let me know if this is an easy repair or if I'm going to run into a mess by disassembling the regulator. If you can offer advice on how to perform this repair, I'd appreciate that as well.