Recent content by roozter

Controller, Heating Element and Three-Piece Valve sold. I'll create a new listing for just the kettle. This listing is done/sold.

I upgraded my entire brewing setup and this great kettle has to go. You can't buy these anymore since BruGerar decided to focus on commercial. The kettle is in like new shape with a weldless tri-clamp for the low watt 5500 W ripple element. Element works great and the tri-clamp makes it easy...

I am also having issues with my RTD PT100. The temp probe has been acting up. It is consistently 20 degrees Fahrenheit too hot. I have tried calibrating in an ice bath and that has lead to being as much as 100 degrees off but only sometimes. I used an ohm meter to measure at the probe...

Thanks, that was my option 2. You are thinking just go straight for that one? I guess I don't have to enlarge the hole in the kettle, it would just be smaller than the radius flange ID.

I am also looking for the 1.5 TC pull through tool. But I also have questions. My current setup uses a ripple heater element in the hot pod EWL3 enclosure with the weldless install. The current hole size is 1.25" and was done with a greenlee punch in my Bru Gear ProBoiler 15. I want to be...