Voltage will be 240, received a free contacter with only spade connections. But it rated 30A/600V so I was thinking of adding it to my panel but a little afraid of the spades.
My brother in law found me a CO2 regulator in almost new state, only problem is that it's made for paintball tanks. The housing is a standard left hand thread been looking online if I can buy a connection for my 10# tank but no luck.
Anybody know where I can purchase one?
I probably go the Auber PID route first, and then expand to the brewtroller. Later when I get the brewtroller I will re-use the PID for fermentation or a kegerator.
There are probably good crimper's at Lowes or HD that are cheaper and will do the trick. The point I'm making is that soldering will weaken the crimp, google it if you don't believe me.
My mentor always used the following comparison, you use a screwdriver for a screw and then a hammer to hit it...
To get a good crimp use a ratchet crimper with the appropriate die. This will make sure the connector and cable are "welded" together under the high pressure. You will never be able to apply enough pressure using a plier as it will just squeeze and create a space somewhere else and weaken the...
Thanks for the options, think I will get a male camlock with a barb and create a 2' hose. This way I can create a 'regular' hose anytime by connecting it to one of the female camlock hoses.
Looking at adding camlocks when I get my pump, just wondering how people use them to transfer to a carboy.
I will be creating a whirlpool using the pump and immersion chiller. After reaching the correct temp I will disconnect the whirlpool and move hose to the carboy. Will the camlock fit in...